|
Objects contain groups that contain both parameters and parameter tables. Use the Parameter Tables to configure the Access Point. The Access Point CLI is under development as this document is being prepared; therefore, some table cells are blank where a feature has not yet been implemented or information needs validation. Columns used on the tables include: - Name - Parameter, Group, or Table Name
- Type - Data type
- Values - Value range, and default value, if any
- ACC. - Indicates access type. R = Read Only (show), RW = Read-Write, can be "set", W = Write Only
- CLI Parameter - Parameter name as used in the Access Point
- Verify or Config at Setup - Use this column to help focus on critical parameters when initializing and setting up Access Points.
Access Point network objects are associated with Groups. The network objects are listed below and associated parameters are described in the following Parameter Tables: - System - Access Point system information
- Network - IP and Ethernet information
- Wireless Interface - Wireless Interface (or you can say Wireless Card) Information
- SNMP - Management information
- RADIUS - RADIUS Authentication and Accounting information
- Telnet - Telnet Port setup
- Serial Port - Serial Port setup
- TFTP - Set up for file transfers. Specify IP Address, file name, and file type.
- HTTP - Use the graphical web browser interface
- Link Integrity - Monitor link status
- Wireless Interface Security - Security settings
- Ethernet Filtering - Enable and disable specific addresses
- Static MAC Address Filtering - Enable and disable specific addresses
- Spanning Tree - Used to help prevent network loops
- Storm Threshold - Set multicast rate
- MAC Access - Control access my Media Access Control number
- DHCP Server - Enable or disable dynamic host configuration
|
