Advanced Network Configuration Settings
[ Contents ] [ Avaya website ]

For Basic Network Configuration settings consult Basic Configuration Tabs.

DHCP Server Configuration Tab

Use DHCP configuration to provide dynamic client IP Addresses from one or more IP Pool Tables. Create IP Pool Tables by specifying a Start IP Address and an End IP Address.

  • DHCP Server Status. Select Enable to allow the AP-3 to assign clients IP Addresses from IP Pool Tables. Select Disable to prevent client IP Address assignment from the AP-3.
You must have at least one entry in the DHCP Server client IP Address assignment table before you can enable the DHCP Server Status feature.
  • Subnet Mask. Read-only value of the AP-3 mask.
  • Default Router IP Address. Enter the default Gateway IP Address.
  • DNS IP Address. Enter the Domain Name Server IP Address.
  • Default Lease Time. Enter the default time value (seconds) for clients to retain the assigned IP Address. DHCP automatically renews IP Addresses without client notification.
  • Maximum Lease Time. Enter the maximum time value (seconds) for clients to retain the assigned IP Address. DHCP automatically renews IP Addresses without client notification.

IP Pool Table setup

To add an entry, click Add, and then specify the start and end IP Address.

  • Start IP Address. Enter the starting IP Address for this IP Pool Table.
  • End IP Address. Enter the ending IP Address for this IP Pool Table.
  • Comment. Enter related information.
  • Status. Shows enabled/disabled status.

To edit or delete an entry, click Edit. Edit the information, or select Enable, Disable, or Delete from the Status pull-down menu.

Link Integrity Tab

This feature checks the link between the AP-3 and connected network server(s). If the link goes down, the client will connect to another AP-3 in your network that still communicates with the server.

  • Link Integrity Status. Select Enable to activate the Link Integrity feature.
  • Poll Interval. Set the interval (in milliseconds) between polls. This value should be greater than 500 ms.
  • Poll Retransmissions. Set the number of times a poll should be retransmitted before the link is considered down.

IP Address Table setup

To add an Target IP Address entry, click Add, and then specify the IP Address of the servers you want to check.

  • Target IP Address. Enter the IP Address
  • Comments. Enter related information.
  • Status. Shows enabled/disabled status. A disabled status only means that the AP-3 is not checking the link, for example, when the network server is being serviced.

To edit or delete an entry, click Edit. Edit the information, or select Enable, Disable, or Delete from the Status pull-down menu.